For more products please visit http://www.weedo.ltd / https://www.weedo3d.com
Sidebar
connect_printer:me40pro
This is an old revision of the document!
Instruction for changing parameters (PID or other parameters)
You have purchased our ME40Pro 3D printer 
. You can reset some parameters for the printer with computer
You need to download a serial debugging tool to change the parameters for this printer.
You need to refresh the firmware of your printer to V2.4.0
Important Firmware Parameters
1.PID
What is PID Tuning?
Before starting with the guide on how to do a PID tuning, we fist need to understand the concept.
In just a few words, PID is an algorithm that makes sure the heaters for both hotend and heatbed supply just enough heat in order to have the difference between the highest and lowest temperature as small as possible.
If you are interested in learning more about what is PID, you can check this Wikipedia article where a PID controller is described.
If you still have questions, please contact our customer service. Email:salesservice@wiibooxtech.com — peter 2020/06/11 01:41
connect_printer/me40pro.1592463796.txt.gz · Last modified: 2020/09/21 13:43 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
