Differences

This shows you the differences between two versions of the page.

--- content:how_to_connect_tina2_to_wiibuilder [2022/05/07 14:02]
ayumi
+++ content:how_to_connect_tina2_to_wiibuilder [2022/05/07 14:51] (current)
ayumi
@@ Line 6: / Line 6: @@
 Step1: After configuring the network through Wiibuilder or Manual editing, obtain the IP address.（See “Set Up Wi-Fi Network” ）\\
+{{:content:图片_1.png?400|}}\\
 \\
 Step2: Open the Wiibuilder. Click“WLAN Connection”, enter or choose the IP address, click"Connect".\\
@@ Line 20: / Line 21: @@
 Step3: Open the Wiibuilder. Click“WLAN Connection”,choose "COM3"for Windows  or "/dev/*****" for MacOS, click "Connect".\\
 {{:content:屏幕截图_2022-05-07_134517_2.png?400|}}\\
-{{:content:屏幕截图_2022-05-07_134716.png?400|}}
+{{:content:屏幕截图_2022-05-07_134716.png?400|}}\\
+\\
+===== The reason for the failure to connect to the network =====
+  - It is not possible to use the 5GWiFi network. It needs to operate at 2.4 GHz network frequency.
+  - Please turn off VPN.
+  - Please turn off Windows defender settings, make sure the 3D printer and computer are the same subdomain.
+  - Mobile phones need to be operated with WIFI.The 3D printer and phones need to use the same subdomain.
+  - Keep the TF card inserted.
+  - WiFi name cannot be used in Chinese.
+==== How to turn off Windows defender ====
+Method 1:Turn off all defender\\
+Method 2:Allow Wiibuilder through defender\\
+{{:content:5.png?400|}}