For more products please visit http://www.weedo.ltd / https://www.weedo3d.com
Sidebar
content:printing_setting
This is an old revision of the document!
Set XY Zoffset For Dual Nozzles
When the new nozzle is replaced and the belt tension of the X is readjusted, the XY offset of the nozzle will change and the XY offset needs to be readjusted. The specific methods are as follows:
Method One:
X Coarse tune:
Loading two-color filament in the left and right nozzle which is easy to observe.
Print the two-color test file in the TF card, the file name is NozzleCoarseTune.gcode.
Printer interface selection:
The 351 parameters is selected by default for printing.
content/printing_setting.1598598956.txt.gz · Last modified: 2020/09/21 13:43 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
