daily_maintenance:3.edge_warping_problem
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
daily_maintenance:3.edge_warping_problem [2020/09/10 13:19] peter created |
daily_maintenance:3.edge_warping_problem [2020/09/21 13:45] (current) |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ====Solution===== | ====Solution===== | ||
| - | 1. See question 1 Printing is not glued to the platform.[[daily_maintenance: | + | 1. See this reason: |
| 2. The air temperature is too low, balance printing and indoor temperature difference, printing warped edge in winter can try to turn on the air conditioner.\\ | 2. The air temperature is too low, balance printing and indoor temperature difference, printing warped edge in winter can try to turn on the air conditioner.\\ | ||
| Line 15: | Line 15: | ||
| 3. Reduce the layer height printing and reduce the printing pressure.\\ | 3. Reduce the layer height printing and reduce the printing pressure.\\ | ||
| - | 4. The pad is used as the bottom | + | 4. Use Raft in the slicing software |
| - | 5. Increase the printing temperature\\ | + | 5. Increase the printing temperature.\\ |
daily_maintenance/3.edge_warping_problem.1599715195.txt.gz ยท Last modified: 2020/09/21 13:43 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
