User Tools

Site Tools

Trace:
daily_maintenance:6._circles_are_not_round

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision 		Previous revision
daily_maintenance:6._circles_are_not_round [2020/09/10 15:01]
peter created 		daily_maintenance:6._circles_are_not_round [2020/09/21 13:45] (current)
Line 6: Line 6:
 ---- ----
  
-* * The printed circular structure is measured with calipers, and it is found that the circumferential roundness deviates too much * *\\+**The printed circular structure is measured with calipers, and it is found that the circumferential roundness deviates too much.**
  
 ====Possible Reasons==== ====Possible Reasons====
Line 28: Line 28:
 2. When the diameter of the red line "3" is the smallest, the sliding sprinkler assembly checks whether the Y direction is smooth and the Y direction belt is too loose, and tighten the Y motor belt if normal. 2. When the diameter of the red line "3" is the smallest, the sliding sprinkler assembly checks whether the Y direction is smooth and the Y direction belt is too loose, and tighten the Y motor belt if normal.
  
-3. When the diameter of the red line in the "2" direction is the smallest and the diameter in the "4" direction is the largest, the distance between the X platform and the left side of the front drive shaft can be increased. Figure 3. Red line "1" distance. 
  
-4. When the diameter of the red line "4" is the smallest, and the diameter of the "2" direction is the largest, the distance between the X platform and the right side of the front drive shaft can be increased. Figure 3. Red line "2" distance.+3. When the diameter of the red line in the "2" direction is the smallest and the diameter in the "4" direction is the largest, it may be that the Y direction is not horizontal, then you need to loosen the two screws in the position shown by the arrow in the following picture, and manually adjust the two aluminum profiles in the red circle to move slightly to the right, and then tighten the two screws. This is shown in the following figure. 
 + 
 +4. When the diameter of the red line "4" is the smallest, and the diameter of the "2" direction is the largest, it may be that the Y direction is not horizontal, so it is necessary to loosen the two screws at the position shown by the arrow in the following picture, and manually adjust the two aluminum profiles in the red circle to move slightly to the left. Tighten two more screws. This is shown in the following figure. 
 + 
 +{{:daily_maintenance:pasted:20200910-000937.png}}
  
  
daily_maintenance/6._circles_are_not_round.1599721318.txt.gz · Last modified: 2020/09/21 13:43 (external edit)

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki