faq:raftsupport
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
faq:raftsupport [2018/10/22 18:48] caojie |
faq:raftsupport [2020/09/21 13:45] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| Firstly, please select the platform adhesion type “Raft” in the Cura when slicing the model, see below photo..\\ | Firstly, please select the platform adhesion type “Raft” in the Cura when slicing the model, see below photo..\\ | ||
| - | {{: | + | {{: |
| + | \\ | ||
| If still can not stick, please adjust the distance between nozzle and platform, see below tutorial. | If still can not stick, please adjust the distance between nozzle and platform, see below tutorial. | ||
| https:// | https:// | ||
| \\ | \\ | ||
faq/raftsupport.1540205338.txt.gz · Last modified: 2020/09/21 13:43 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
