Differences

This shows you the differences between two versions of the page.

--- fdm:f152 [2018/10/18 21:20]
caojie
+++ fdm:f152 [2020/09/21 13:45] (current)
@@ Line 1: / Line 1: @@
 ====WEEDO F152 FAQ====
-  - [[filamentchange|Is the filament change operation run once every time you turn it on?]]
+  - [[faq:filamentchange|Is the filament change operation run once every time you turn it on?]]
+  - [[faq:takemodel|After the model is printed, can I take the model by hand immediately?]]
+  - [[faq:notstick|What should I do if the bottom of the printed model is not strong or the model is running?]]
+  - [[faq:extruderclogged|The extruder is clogged or no filament out]]
+  - [[faq:sdcarderror|Sdcard can't read file]]
+  - [[faq:replacenozzle|Replace the nozzle]]
+  - [[faq:gcodeslow|How to solve the slicing program generation gcode is too slow?]]
+  - [[faq:misplacement|Printing misplacement]]
+  - [[faq:notform|Printing model not form]]
+  - [[faq:warp|Model warping reason]]
+  - [[faq:5cm|The machine prints the model height and can only stop printing when it reaches 5cm.]]
+  - [[faq:cleaningnozzle|Cleaning the nozzle]]