WEEDO F152 FAQ

  1. Is the filament change operation run once every time you turn it on?
  2. After the model is printed, can I take the model by hand immediately?
  3. What should I do if the bottom of the printed model is not strong or the model is running?
  4. The extruder is clogged or no filament out
  5. Sdcard can't read file
  6. Replace the nozzle
  7. How to solve the slicing program generation gcode is too slow?
  8. Printing misplacement
  9. Printing model not form
  10. Model warping reason
  11. The machine prints the model height and can only stop printing when it reaches 5cm.
  12. Cleaning the nozzle