=====Set up the printer after installation=====

====1. Check the machine voltage after installation.====

{{:machine_debug:pasted:20200831-002026.png}}

====2.Select Language=====
Click the front button to turn on the computer, and select the desired language after turning it on.\\

{{:machine_debug:pasted:20200831-002118.png}}

====3.Enters the POST====

====4.Bed Leveling====

 Click ‘Maintenance’—'Bed leveling’ \\

{{:machine_debug:pasted:20200831-002225.png}}\\

Adjust the nut under the four corners of the platform in turn so that the distance between the nozzle and the platform is in the thickness of a piece of paper. After leveling, the interface displays a measured reference flatness of the platform.\\

{{:machine_debug:pasted:20200831-002248.png}}\\

====5.Set Zoffset====

Click ‘Maintenance’—'Z Offset’\\

click the upper and down icon the nozzle will move up and down, make the distance between the nozzle and the platform is in the thickness of a piece of paper, save the parameters.\\

{{:machine_debug:pasted:20200831-002442.png}}\\

====6.Load filament====

Straighten the filament and insert it into the nozzle. Click the filament feed icon.\\

{{:machine_debug:pasted:20200831-002507.png}}

====7.Printer test file====

Insert the TF card into the right side of the printer and print the test file in the TF card.