Differences

This shows you the differences between two versions of the page.

--- print_accuracy_debugging:printing_setting_f152s [2020/09/25 17:33]
peter
+++ print_accuracy_debugging:printing_setting_f152s [2020/09/25 17:37] (current)
peter
@@ Line 29: / Line 29: @@
-. When the diameter of the red line in the "2" direction is the smallest and the diameter in the "4" direction is the largest, it may be that the Y direction is not horizontal, then you need to loosen the two screws in the position shown by the arrow in the following picture, and manually adjust the two aluminum profiles in the red circle to move slightly to the right, and then tighten the two screws. This is shown in the following figure.
+. When the diameter of the red line in the "2" direction is the smallest and the diameter in the "4" direction is the largest, the distance between the X platform and the left side of the front driveshaft can be increased. Increase the distance of A.
+. When the diameter of the red line "4" is the smallest, and the diameter of the "2" direction is the largest, the distance between the X platform and the right side of the front driveshaft can be increased. Increase the distance of B.
-. When the diameter of the red line "4" is the smallest, and the diameter of the "2" direction is the largest, it may be that the Y direction is not horizontal, so it is necessary to loosen the two screws at the position shown by the arrow in the following picture, and manually adjust the two aluminum profiles in the red circle to move slightly to the left. Tighten two more screws. This is shown in the following figure.
 {{:print_accuracy_debugging:pasted:20200925-103326.png}}

User Tools

Site Tools

Differences

Page Tools