set_up_wifi_network:tina2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
set_up_wifi_network:tina2 [2022/05/07 11:32] ayumi |
set_up_wifi_network:tina2 [2022/05/18 11:11] (current) ayumi |
||
|---|---|---|---|
| Line 24: | Line 24: | ||
| {{: | {{: | ||
| \\ | \\ | ||
| - | Step4: Turn on the 3D printer，print | + | Step4: Turn on the 3D printer，print"wifi.gcode".\\ |
| - | {{:set_up_wifi_network:0421_9.png? | + | {{:content:2022-5-7-1.png? |
| \\ | \\ | ||
| - | Step5: After WIFICAM | + | Step5: After WIFI is connected the Internet, the obtained IP address will be displayed on the printer screen. |
| - | + | ||
| - | ===== Method 1. Using the APP distribution network ===== | + | |
| - | + | ||
| - | ====Download the Andriod APP-Poloprint1.3.1 for the first time==== | + | |
| - | App download: [[http:// | + | |
| - | ===After the download is completed, the installation is completed. After the installation is completed, the first time the application is opened, the interface is displayed. The wizard interface is an introduction to the use of instructions on the app. The specific usage requires a tutorial corresponding to the specific model. This tutorial is for Tina2=== | + | |
| - | ===Step 1: Enter the WIFI password in the network where the mobile APP brush WIFI settings interface (do not click OK first)=== | + | |
| + | ===== Method 2: Manual editing ===== | ||
| + | Step1: | ||
| + | {{ : | ||
| + | \\ | ||
| + | Step2: Enter your home 2.4G network name and network password, save to TF card.\\ | ||
| + | {{: | ||
| + | {{: | ||
| + | \\ | ||
| + | Step3: Turn on the 3D printer，print “wifi.gcode”.\\ | ||
| + | {{: | ||
| + | \\ | ||
| + | Step4: After WIFI is connected the Internet, the obtained IP address will be displayed on the printer screen. | ||
| + | \\ | ||
| + | ===== Method 3: Using the APP distribution network ===== | ||
| + | Step1: Download the Andriod APP-Poloprint for the first time.\\ | ||
| + | {{ : | ||
| + | \\ | ||
| + | Step2: Search the network for the corresponding serial number.\\ | ||
| + | {{: | ||
| + | \\ | ||
| + | \\ | ||
| + | Step3: After the download is completed, the installation is completed.Open the APP，click" | ||
| + | {{: | ||
| + | \\ | ||
| + | Step4: Restart the machine. After WIFI is connected the Internet, the obtained IP address will be displayed on the printer screen. | ||
| + | \\ | ||
set_up_wifi_network/tina2.1651894351.txt.gz · Last modified: 2022/05/07 11:32 by ayumi
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
