This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
sparkone_wifi_setting [2019/11/22 16:00] peter created |
sparkone_wifi_setting [2020/09/21 13:45] (current) |
||
|---|---|---|---|
| Line 21: | Line 21: | ||
| If only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\ | If only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\ | ||
| \\ | \\ | ||
| - | ===设置方法2: nmcli=== | + | ===Setting method2: nmcli=== |
| + | |||
| + | 1. Enter: nmcli dev wifi connect SSID password PWD\\ | ||
| + | SSID is your wifi name\\ | ||
| + | PWD is your wifi password\\ | ||
| + | 2. After the command is successfully executed, it will be displayed on the SparkOne screen. WIFI: | ||
| + | 3. Unplug the power supply and network cable, and power cycle. After SparkOne connects to the Wifi network successfully, | ||
| + | |||
| + | If the only Wait! is displayed on the screen and there is no Wifi IP address, try the above steps again.\\ | ||
| - | 1. 输入指令 nmcli dev wifi connect SSID password PWD\\ | ||
| - | SSID 是你的无线网络名称\\ | ||
| - | PWD 是你的无线网络密码\\ | ||
| - | 2. 指令执行成功后,SparkOne屏幕上会显示 WIFI: | ||
| - | 3. 拔掉电源和网线,重新上电,SparkOne连接Wifi网络成功后,会在屏幕上显示IP地址\\ | ||
| - | 如果屏幕上只显示 Wait!,没有出现Wifi的IP地址,请尝试重新执行上述步骤。\\ | ||
| \\ | \\ | ||
| - | ===注意事项=== | + | ===Precautions=== |
| - | 如果运行nmcli dev wifi connect指令后,无法连接wifi网络,并提示以下信息\\ | + | If you run the "nmcli dev wifi connect" command, you cannot connect to the wifi network and prompt the following information.\\ |
| Connection activation failed: (7) Secrets were required, but not provided | Connection activation failed: (7) Secrets were required, but not provided | ||
| - | 请检查你的无线路由器的加密模式是否为 | + | |
| + | Please check if your wireless router' | ||