x40:firmware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
x40:firmware [2021/01/09 13:25] caojie ↷ Page moved and renamed from firmware:x40 to x40:firmware |
x40:firmware [2021/08/16 10:51] (current) peter |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====Machine Firmware==== | ====Machine Firmware==== | ||
| + | |||
| + | ===X40 V1.2.0=== | ||
| + | 1. Add the Baby Z offset in the printing interface, you can set baby Z offset when you printing.\\ | ||
| + | {{: | ||
| + | 2. Add the dual Nozzle switch function in the printing interface.\\ | ||
| + | {{: | ||
| + | 3. Add the function that: when the runout sensor trigger, the printing extruder will switch to another extruder\\ | ||
| + | 4. Add the Y direction '' | ||
| + | 5. Fixed an issue where bias parameters could not be saved.\\ | ||
| + | 6. Fixed the problem of abnormal start-up and continuous call.\\ | ||
| + | 7. Fixed an issue where there was no push message after the printing was completed.\\ | ||
| + | 8. Fixed the problem of the unlimited position of the switch in Jog mode.\\ | ||
| + | 9. Fixed the problem that the missing material wire will be reported if there is no material wire in the extruder on the other side when printing the single sprinkler model.\\ | ||
| + | 10. Fixed the problem that the left sprinkler returned to the drawing wire after the execution of the G28 instruction.\\ | ||
| + | 11. Fixed an issue where you can't continue to print in copy and mirror mode.\\ | ||
| + | 12. Fixed a problem where the right extruder did not return to position after printing was paused in copy and mirror mode.\\ | ||
| + | 13. Fixed an issue where the right fan started abnormally when the left fan was started in automatic docking mode.\\ | ||
| + | 14. Fixed an issue where the X coordinate offset was not reset after copying and mirroring mode printing.\\ | ||
| + | |||
| + | <WRAP center round download 30%> \\ | ||
| + | [[https:// | ||
| + | </ | ||
| + | |||
| + | |||
| + | ===X40 V1.1.2=== | ||
| + | 1. Fixed an issue where the zoffset parameters were emptied after the factory settings were restored.\\ | ||
| + | 2. Modify the prompt message for height adjustment of double sprinklers.\\ | ||
| + | 3. Fixed the problem that there is no prompt message in the adjustment interface of the proximity switch.\\ | ||
| + | 4. Increase the position of the sprinkler in the X direction before resuming printing.\\ | ||
| + | 5. When printing a WiFi disk file, clicking Settings will display a prompt that the parameters cannot be set.\\ | ||
| + | |||
| + | < | ||
| + | [[https:// | ||
| + | </ | ||
| + | |||
| + | |||
| + | ===X40 V1.1.1=== | ||
| + | |||
| + | < | ||
| + | [[https:// | ||
| + | </ | ||
| + | |||
| ===X40 V1.1.0=== | ===X40 V1.1.0=== | ||
x40/firmware.1610169919.txt.gz · Last modified: 2021/01/09 13:25 by caojie
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
