x40:howto_set_up_wifi_network []

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
======Set up WiFi Network======


You have purchased our Independent Dual Extruder 3D printer X40 LOL.
Here is the method to Setup the Wifi Network For X40
\\
If you still have questions, please contact our customer service. Email:salesservice@wiibooxtech.com\\
\\
WIFICAM(The name of our wifi equipment)wireless network has two working modes:AP mode and STA mode.
You can use AP mode to set the IP for your printer.\\
\\
**Notice:The device does not support 5G network.**\\
\\
=====Set up WiFi with webpage=====
Step1: The name of the hotspot SSID is "WIFICAMWD******",which is the device number, and there is no password.
\\
{{:set_up_wifi_network:0421_1.png?400|}}\\
\\
Step2: Use your computer or mobile phone connect this WiFi.\\
\\
Step3: Use a browser(the browser on the device used in Step2)to access http://10.10.0.1:88/
\\
Then you can access to the WiFi network management page.\\
{{:x40:0421_2.png?400|}}\\
\\
Step4: On this page ,it can automatically scan the nearby WiFi network.Click on your network name, enter your WiFi password, and wait for a moment, WIFICAM will try to connect to the network.\\
{{:set_up_wifi_network:0421_3.png?400|}}\\
{{:set_up_wifi_network:0421_4.png?400|}}\\
\\
Step5: After WIFICAM is connected to the Internet, the obtained IP address will be displayed on the printer screen.\\
{{:set_up_wifi_network:0421_5.png?400|}}\\
\\
=====Set up WiFi with Wiibuilder(Windows)=====
You can also use the Wiibuilder to set the IP for your printer.\\
\\
Step1: After the computer is connected to the network, open the Wiibuilder.\\
\\
Step2: Click “WLAN Connection”-“WiFi Profile”.\\
{{:set_up_wifi_network:0421_6.png?400|}}\\
{{:set_up_wifi_network:0421_7.png?400|}}\\
\\
Step3: Enter your network password，click “Save”, save to TF card.\\
{{:set_up_wifi_network:0421_8.png?400|}}\\                                                                                                               
\\
Step4: Turn on the 3D printer，print “wifi.gcode”.\\
{{:set_up_wifi_network:0421_9.png?400|}}\\
\\
Step5: After WIFICAM is connected the Internet, the obtained IP address will be displayed on the printer screen.
User Tools

Site Tools

Page Tools
