x40:howto_use_cura
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
x40:howto_use_cura [2022/04/21 16:23] ayumi |
x40:howto_use_cura [2022/04/21 16:50] (current) ayumi |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | =====Connect Printer to Cura===== | + | ====== Connect Printer to Cura ====== |
| - | **You have purchased our Independent Dual Extruder 3D printer X40 LOL.// | + | **You have purchased our Independent Dual Extruder 3D printer X40 LOL. |
| Here is the method to Connect Printer to Cura** | Here is the method to Connect Printer to Cura** | ||
| \\ | \\ | ||
| **If you still have questions, please contact our customer service. Email: | **If you still have questions, please contact our customer service. Email: | ||
| \\ | \\ | ||
| - | ===== The first way : The network connection ===== | + | =====The first way : The network connection===== |
| Step1: After configuring the network through the web page or Wiibuilder, obtain the IP address.（See “Set Up Wi-Fi Network” ）\\ | Step1: After configuring the network through the web page or Wiibuilder, obtain the IP address.（See “Set Up Wi-Fi Network” ）\\ | ||
| + | {{: | ||
| \\ | \\ | ||
| Step2: Open the Cura(weedo). Click“Manage printers”, | Step2: Open the Cura(weedo). Click“Manage printers”, | ||
| {{: | {{: | ||
| + | {{: | ||
| + | {{: | ||
| + | \\ | ||
| + | Step3: Click“Connect OctoPrint ”,enter the IP address, and take a name. Click“Ok”.\\ | ||
| + | {{: | ||
| + | {{: | ||
| + | {{: | ||
| + | \\ | ||
| + | Step4: Click“Connect | ||
| + | {{: | ||
| + | {{: | ||
| + | \\ | ||
| + | ===== The second way : USB cable connection ===== | ||
| + | Step1: Connect the printer and computer with a USB cable.\\ | ||
| + | \\ | ||
| + | Step2: You need to download the CH340 driver (on the download page) for the first connection.\\ | ||
| + | {{: | ||
| + | \\ | ||
| + | Step3: Open the Cura(weedo). Click“Manage printers”, | ||
| + | {{: | ||
| + | {{: | ||
| + | {{: | ||
| + | \\ | ||
| + | Step4: Start to “MONITOR”.\\ | ||
| + | {{: | ||
x40/howto_use_cura.1650529420.txt.gz · Last modified: 2022/04/21 16:23 by ayumi
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
