Differences

This shows you the differences between two versions of the page.

--- x40:howto_use_wificam [2020/09/07 15:08]
peter created
+++ x40:howto_use_wificam [2021/01/09 13:23] (current)
caojie ↷ Links adapted because of a move operation
@@ Line 6: / Line 6: @@
 <WRAP center round info 60%>\\
-[[set_up_wifi_network:x40|Setup WiFi Network]]
+[[x40:howto_set_up_wifi_network|Setup WiFi Network]]
 </WRAP>
 {{:wificam_use:pasted:20200907-000054.png}}
+====Open Wiibuiler====
+Open Wiibuiler click the **'octoprint icon'** and type into the IP address, and click **'connect'**
+**Please make sure your computer connect into the same internet with the printer.**
+{{:wificam_use:pasted:20200907-003825.png}}
+{{:wificam_use:pasted:20200907-003927.png}}
+{{:wificam_use:pasted:20200907-004104.png}}
+You can slice the stl file to Gcode file and click **'Upload And Print'** then the Gcode file will upload to the printer and start printing after upload finished.
+{{:wificam_use:pasted:20200907-004341.png}}