=====How to use wificam for video Monitoring=====

====Check the IP address on the Screen of X40====

Check the IP address on the right corner of the printer, shown in the below picture.\\

<WRAP center round info 60%>\\
[[x40:howto_set_up_wifi_network|Setup WiFi Network]]
</WRAP>


{{:wificam_use:pasted:20200907-000054.png}}

====Open Wiibuiler====

Open Wiibuiler click the **'octoprint icon'** and type into the IP address, and click **'connect'**

**Please make sure your computer connect into the same internet with the printer.**

{{:wificam_use:pasted:20200907-003825.png}}

{{:wificam_use:pasted:20200907-003927.png}}

{{:wificam_use:pasted:20200907-004104.png}}

You can slice the stl file to Gcode file and click **'Upload And Print'** then the Gcode file will upload to the printer and start printing after upload finished.

{{:wificam_use:pasted:20200907-004341.png}}