x40:r73
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
x40:r73 [2021/01/11 16:09] caojie created |
x40:r73 [2021/01/11 16:36] (current) caojie |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| =====Introduction===== | =====Introduction===== | ||
| ---- | ---- | ||
| - | R73 is the 7th generation 3D printer controller developed by WEEDO3D. It uses a 32bit large capacity mcu, stm32F103vet6, | + | R73 is the 7th generation 3D printer controller developed by WEEDO3D. It uses a 32bit large capacity mcu, stm32F103vet6, |
| \\ | \\ | ||
| - | =====Features===== | + | =====Specifications===== |
| ---- | ---- | ||
| + | * Microcontroller: | ||
| + | * USB Chip: CH340G | ||
| + | * Stepper Motor Driver: X1, X2, Y use TMC2208, Z, E1, E2 use A4988 | ||
| + | * Stepper Motor Current Regulation: 4-channel PWM | ||
| + | * Endstop: X1, X2, Y-Max, Z-Max | ||
| + | * Runout Sensor: RUNOUT1, RUNOUT2 | ||
| + | * Fan: Extruder Fan x4, Case Fan x1 | ||
| + | * Z Probe: Proximity Switch x1 | ||
| + | * Heated bed: 100k thermistor, 24V, Max to 300W | ||
| + | * LCD: DGUS Touch Screen | ||
| + | * WIFI: WIFICAM | ||
| + | * Storage: TF Card | ||
| + | * Power Input: 24V/20A | ||
| \\ | \\ | ||
| - | \\ | + | =====Port |
| - | =====Port | + | |
| ---- | ---- | ||
| {{: | {{: | ||
x40/r73.1610352567.txt.gz · Last modified: 2021/01/11 16:09 by caojie
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
