For more products please visit http://www.weedo.ltd / https://www.weedo3d.com
Sidebar
set_up_wifi_network:tina2
This is an old revision of the document!
Table of Contents
Set up Wi-Fi network
Notices for Network Setting：
- It is not possible to use the 5GWiFi network. It needs to operate at 2.4 GHz network frequency.
- Mobile phones need to be operated with WIFI
- Local WiFi connection recommendation should not exceed 10 devices
- When installing, you need to give the mobile APP network location permission.
- Printers need to be connected in a good network environment (mobile WIFI interface can be used to check whether the network environment is generally above)
- WiFi name cannot be used in Chinese
- If you have any questions about the printer, please contact us. Our email address is：support@weedo3d.com
Method 1:Set up WiFi with Wiibuilder(Windows)
You can also use the Wiibuilder to set the IP for your printer.
Step1: After the computer is connected to the 2.4G network, open the Wiibuilder,choose “TINA2”printer.
Step2: Click “WLAN Connection”-“WiFi Profile”.
Step3: Enter your network password，click “Save”, save to TF card.
Step4: Turn on the 3D printer，print “wifi.gcode”.
Step5: After WIFICAM is connected the Internet, the obtained IP address will be displayed on the printer screen.
Method 2: Manual editing
Step1:Download this .gcode
Step1: Enter your network password，click “Save”, save to TF card.
Step4: Turn on the 3D printer，print “wifi.gcode”.
Step5: After WIFICAM is connected the Internet, the obtained IP address will be displayed on the printer screen.
Method 1. Using the APP distribution network
Download the Andriod APP-Poloprint1.3.1 for the first time
App download: External Link
After the download is completed, the installation is completed. After the installation is completed, the first time the application is opened, the interface is displayed. The wizard interface is an introduction to the use of instructions on the app. The specific usage requires a tutorial corresponding to the specific model. This tutorial is for Tina2
Step 1: Enter the WIFI password in the network where the mobile APP brush WIFI settings interface (do not click OK first)
set_up_wifi_network/tina2.1651895437.txt.gz · Last modified: 2022/05/07 11:50 by ayumi
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
