For more products please visit http://www.weedo.ltd / https://www.weedo3d.com
Sidebar
x40:howto_set_up_wifi_network
This is an old revision of the document!
Set up WiFi Network
You have purchased our Independent Dual Extruder 3D printer X40 
.
Here is the method to Setup the Wifi Network For X40
If you still have questions, please contact our customer service. Email:salesservice@wiibooxtech.com
WIFICAM(The name of our wifi equipment)wireless network has two working modes:AP mode and STA mode.
You can use AP mode to set the IP for your printer.
Notice:The device does not support 5G network.
Set up WiFi with webpage
Step1:The name of the hotspot SSID is
x40/howto_set_up_wifi_network.1650521661.txt.gz · Last modified: 2022/04/21 14:14 by ayumi
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
